Out on the road, a cold RV interior kills comfort fast. Forced-air units thump and blow, and propane often leaves you with hot and cold patches—plus the operating cost adds up. What you want is heat that hits quickly, stays quiet, and lives within your tight footprint. What’s under the hood We built this RV electric heater around infrared radiant heat, using a low-glow carbon fiber element. It warms people and surfaces directly instead of wasting time heating the air, so you feel the heat within seconds of flipping the switch. It runs on 120V shore power and standard RV outlets, pulling 1500W—enough output to matter, without tripping typical circuits. The footprint is small and the housing is low-profile, so it tucks neatly under a bench, beside a seat, or within reach of the bed. Inside, a built-in thermostat holds your set temperature, and tip-over protection shuts the unit off if it gets knocked over. Why it fits the way you live RV life is about practical comfort. Infrared warmth keeps you cozy while you’re reading, cooking, or getting ready in the morning, and it doesn’t blast air that kicks up dust. Because the heat is directional, it helps even out the small cabin feel—fewer drafts, fewer cold spots. The payoff is a calmer interior, lower energy draw compared with running larger heaters, and faster recovery after a cold drive. A few real-world notes This heater is intended for indoor RV use and needs a dedicated 15A circuit. It’s not a whole-RV solution for deep cold, and it performs best when aimed at the main seating or sleeping area. Keep it clear of fabrics, and never run it unattended.