Step outside on a cool evening and you know the feeling—harsh radiant heat that hits you unevenly, drying your skin more than warming you. We tackled that head-on, starting with the spectrum itself. The bulk patio heaters here run on what we call skincare-grade infrared: we tune the output so it’s gentle on exposed skin, yet still delivers deep, even heat.
What matters, technically
We run a purified infrared spectrum that puts comfort first—no irritation. The heart of it is a carbon fiber element inside a sealed quartz tube, giving you radiant heat with minimal visible glare. You’ve got power choices: 1,500–3,000 W, in 120 V or 240 V configurations, and standard NEMA plugs so hookup is straightforward. The footprint is compact—about 24–36 inches tall—and they’re built for outdoor use with an IP rating to keep dust and splashes out. A built-in thermostat holds output steady, and tip-over protection shuts the unit down if it gets bumped.
Why this works outdoors
Outdoor seating lives or dies on comfort. People stick around when warmth arrives fast and stays consistent. Infrared warmth penetrates without heating the air first, so you feel heat where it counts—on people and surfaces—without drafts or noisy fans. That translates to fewer cold spots, fewer draft complaints, and a more natural outdoor living feel. You also get energy efficiency that shows up on the bill: targeted heating keeps power focused on occupied zones, not the whole yard.
The practical details
These patio heaters are meant for dry, covered outdoor spots. Even with a solid IP rating, direct heavy rain or snow isn’t a good fit. For best results, mount the unit 6–8 feet above the floor and keep it 6–8 feet from people. Make sure it’s clear on all sides for airflow. If you’re wiring for bulk installation, size the total load properly—use the correct gauge wire and a grounded circuit. Outdoor evenings end up cozy, not harsh. Just dependable warmth, without the sting.