Infrared bulb with gold reflector

Sat, 06 Jun 2026 01:27:36 +0800

On the fab floor, a 0.3°C drift in bake temperature is enough to throw off critical dimension control and scrap a lot of work. When you’re running soft bake and hard bake, you don’t need hope—you need repeatability. That’s why we built the infrared bulb with a gold reflector to match the reality of the process. What matters under the hood The source is a short-wave infrared emitter in quartz, paired with a gold-plated reflector that keeps the energy focused and the scatter down. Across the bake plate, we target wafer-level thermal uniformity of ±0.1°C, and setpoint stability stays within ±0.5°C under load. Step changes settle in under 2 seconds, so your recipe runs exactly the way it was written. Output holds steady over 5,000+ hours, with less than 5% lumen and temperature decay. The envelope drops into standard lamp housings, and the terminal block matches up with common tool wiring. Why it holds up in production In lithography tracks, the bulb keeps photoresist profiles tight, which improves CD uniformity and cuts down on rework. In packaging, it delivers controlled curing with a clean thermal profile that won’t drive out underfill volatiles. The gold reflector keeps stray heat off the surroundings, so adjacent optics and sensors stay within their thermal budget. Cleanroom Class 1–100 is supported by low outgassing materials and a build that doesn’t shed particles. Energy use drops because the heat goes where it’s supposed to, not into parasitic heating of the chamber. What to watch on install Pay attention to polarity and reflector alignment—misalignment shows up as hot spots and drift. The bulb runs hot, so make sure the fixture is rated for the thermal load and verify cooling before you qualify the process. Schedule the replacement cycle around preventive maintenance windows so you don’t get blindsided by unplanned downtime.

Bulb on The Warm IR Heating Factory

Infrared bulb with gold reflector